Blog
Panel PC Mounting Options: VESA, Panel, Yoke & Open-Frame
Teguar Editorial Team · May 16, 2026
Once you've chosen a panel PC's size and specs, how you physically mount it shapes the whole installation — the cut-out, the sealing, the serviceability and the ergonomics. This guide walks the main mounting methods and when each is the right call.
Mounting is the specification people leave to last and then regret. The method you choose determines whether you cut a hole in a cabinet, how the unit seals against dust and water, whether an operator can adjust the angle, and how easily you service the PC later. Deciding it early avoids expensive rework.
Key takeaways
- The main methods are VESA (arm/wall), panel/flush cut-out, yoke/stand, and open-frame (OEM embed).
- Panel-mount gives the cleanest sealed front but requires a precise cut-out; VESA is flexible and serviceable.
- Yoke mounts allow angle adjustment for operator ergonomics; open-frame suits building into your own product.
- Confirm cut-out dimensions, depth clearance and sealing method before finalising the enclosure design.
The four main methods
Choosing the right mount
Use panel/flush mount. The gasketed front bezel gives you an IP-rated seal against the cabinet, and the electronics sit safely inside. Confirm the exact cut-out size and panel-thickness range.
Use VESA on an arm or stand. It's the most flexible for placement and repositioning, and the easiest to remove for service. Add a privacy or tilt arm as ergonomics require.
Use a yoke/stand so operators can tilt and swivel to their eye line and lighting — valuable where multiple people share a station or glare varies through the day.
Use open-frame and integrate the display behind your own fascia, owning the aesthetics and front sealing — the OEM route.
Whatever you choose, verify three numbers early: the cut-out dimensions, the depth clearance behind the panel, and the panel-thickness range the clamps accept. These constrain your enclosure design and are painful to discover late.
The bottom line
Panel-mount for a clean sealed HMI, VESA for flexible serviceable placement, yoke for adjustable ergonomics, and open-frame when you're embedding the display into your own product. Decide the method up front, confirm the cut-out and clearances, and the install goes smoothly. Size the display first with our panel sizing guide, and browse industrial panel PCs such as the TP-7045-16.
Frequently asked questions
What are the ways to mount a panel PC?
The main methods are VESA (arm/wall/stand), panel or flush cut-out mount, yoke/stand mount for tilt and swivel, and open-frame for embedding into your own enclosure.
What is panel-mount (flush mount)?
The panel PC drops into a precise cut-out in a cabinet door or machine fascia and clamps from behind, leaving a flush, gasketed front bezel — the cleanest look and best front-face IP sealing.
What is VESA mounting?
A standardized hole pattern (commonly 75 or 100 mm) that lets you hang the panel PC on an arm, wall bracket or stand. It's flexible to place and easy to remove for service.
Which mount is best for a sealed HMI?
Panel/flush mount, because its gasketed front bezel seals against the cabinet (e.g. IP65) while the electronics sit protected inside.
What should I check before choosing a mount?
The cut-out dimensions, the depth clearance behind the panel, and the panel-thickness range the mounting clamps accept — these constrain your enclosure and are costly to fix late.